Mehta Sanghvi & Co.

We are involved in offering a broad array of Gas Pre-Heater CO₂ & Nitrous to the clients. These products are manufactured using supreme quality raw, which is sourced from trustworthy vendors of the market. We offer these products in varied specifications to our respected clients who are spread across the globe.

Technical specification & product details are mentioned below:

• Heater available range
• 42V/110V 32 mm dia
• 230V 40 mm dia

Advantage:

• All nut/nipple are detachable

Warning:

• For use with non-combustible welding gases only
• Misatu gas heaters are intended for use on 42V/115V/230V & 50/60 HZ, single phase AC only. Since these are not insulated for outdoor use
• The heaters must be protected from moisture and weather or climatic conditions that could cause electrical equipment to become a hazard use only with 3-wire grounded, electrical extension cord and socket

• 42 V / 110 V : 32 MM DIA
• 230 V : 50 MM REC

• All Nut / Nipple Are Detachable

• For use with non-combustible welding gases only.
• Misatu gas heaters are intended for use on 42V/115V/230V, 50/60 HZ, Single Phase AC only. Since they are not insulated for outdoor use.
• The heaters must be protected from moisture and weather or climatic conditions that could cause electrical equipment to become a hazard use only with 3-Wire grounded, Electrical Extension cord and socket.

TECHNICAL SPECIFICATION & PRODUCT DETAILS

ADVANTAGE : All nut / nipple are detachable

Gas Heaters from Misatu manufacturig keep your welding gases flowing and prevent down-time and damage to your equipement.

As gas is drawn from the supply cylinder, it can reliquify and/or freeze your equipment due to temperature change caused by evaporation, stopping your work cold !

Since they are not insulated for outdoor use, the heaters must be protected from moisture and weather or climatic conditions that could cause electrical equipment to become a hazard.

Misatu gas heater with a heating element, a thermostatic control, and indicater in a totally enclosed unit that heats the gas to a uniform useable temperature before it enters the regulator/flowmeter.